Pyro Industries Quest Plus Provozní pokyny stáhnout pdf (Strana 5)

Safety Precautions

Safety Notice

THlS STOVE MUST BE PROPERLY INSTALLED AND OPERATED IN ORDER TO PREVENT THE POSSIBILITY

OF A HOUSE FIRE. PLEASE READ THlS ENTIRE OWNER'S MANUAL BEFORE INSTALLING AND USING

YOUR

WHITFIELD PELLET STOVE. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN

PROPERTY DAMAGE, BODILY

INIURY OR EVEN DEATH. CONTACT YOUR LOCAL BUILDING OR FIRE

OFFICIALS TO OBTAIN A PERMIT AND INFORMATION ON ANY INSTALLATION RESTRICTIONS AND

INSPECTION REQUIREMENTS IN YOUR AREA.

Installation Disclaimer

THlS STOVES EXHAUST SYSTEM WORKS WITH NEGATIVE COMBUSTION CHAMBER PRESSURE AND A

SLIGHTLY POSITIVE CHIMNEY PRESSURE. THEREFORE, IT IS IMPERATIVE THAT THE EXHAUST SYSTEM

BE GAS TIGHT AND INSTALLED CORRECTLY. SINCE PYRO INDUSTRIES, INC., HAS NO CONTROL OVER

THE INSTALLATION OF YOUR STOVE, PYRO INDUSTRIES GRANTS NO WARRANTY, IMPLIED OR

STATED FOR THE INSTALLATION OR MAINTENANCE OF YOUR STOVE, AND ASSUMES NO

RESPONSIBILITY FOR ANY CONSEQUENTIAL

DAMAGE(S1.

Detailed Safety Precautions

Fuel

With its advanced UltraGrate technology, the Whitfield Quest Plus

designed and approved for the

burning of wood residue pellets with up to

ash content (i.e

...

cardboard, nut hulls, cherry pits etc.). The

burning of agricultural residues

(i.e

....

corn, alfalfa etc.) in pellet form

not permitted. Failure to comply

with this restriction will void all warranties and the safety listing of the stove. Consult with your dealer for

more information on approved pellet fuels and the proper burn grate for the fuels in your area.

Cleaning

There may be some build-up of dust and smaller quantities of soot or creosote in the exhaust

system over the burn season. This will vary due to the ash content of the fuel being burned. A precautionary

inspection on a regular basis

advisable to determine the necessity of cleaning.

Continuous Operation -When operated correctly, the Whitfield Quest Plus cannot be over-fired.

Continuous operation at a maximum burn can, however, shorten the life of the electrical components

(blowers, motors, and electronic controls), and

not recommended. Typical approved operation would

include running at setting numbers Two, Three or Four, with occasional running on number Five during the

coldest periods of the winter. The blower speed control should be turned to

when operating the stove

on the number five heat setting.

Liquid Flammables

Gasoline or other flammable liquids must

NEVER

be used to start or "freshen-up" the

fire. Keep all such liquids well away from the stove at all times.

Ashes -Any ashes removed from the Whitfield Quest Plus must be deposited in a metal container with a

tight-fitting lid. The closed container of ashes should be placed on a noncombustible floor or on the

ground, well away from all combustible materials, pending final disposal. If the ashes are disposed of by

burial in soil or otherwise locally dispersed, they should be retained in the closed container until all cinders

have been thoroughly cooled.

Power

The appliance

provided with a detachable, grounded electrical cord. This cord should be

plugged into a standard, 11 5 volt,

Hz grounded electrical outlet. The approximate power requirement

200

watts, or will peak to approximately

700

watts for 15 minutes when the self-igniter

operating. The

power supply cord must be routed to avoid contact with any of the hot or sharp exterior surface areas of

the stove. In addition, any Whitfield Quest Plus stove that

installed in a mobile home must be:

Connected to a source of outside air, Electrically grounded to the steel chassis and Bolted to the floor in

compliance with and according to H.U.D. requirements unless otherwise specified by state or local authoritiez.

Soot

Formation

For all wood pellet fuel-burning heater products the combustion gases will contain small

particles of fly ash. The fly ash will collect in the exhaust venting system and restrict the flow of the flue

gases, over time. Incomplete combustion, such as occurs during startup, shutdown, or incorrect operation

of the room heater will lead to some soot formation which will collect in the exhaust venting

cystem. The

exhaust venting system should be inspected at least once every year to determine if cleaning

necessary.

1 2 3 4 5 6 7 8 9 10 ... 39 40

Komentáře k této Příručce

Žádné komentáře

Pyro Industries Quest Plus Provozní pokyny Strana 5

Komentáře k této Příručce

Související produkty a manuály pro Kamna Pyro Industries Quest Plus